Does Rubber Trailer Bumper Require Steel Mounting Strip to Install
Question:
Doesnt this bumper require a steel mounting strip on the inside? I have installed one before and it did but I cant seem to find the part number that would be compatible with this bumper.
asked by: Eric E
0
Expert Reply:
The Pre-Drilled Round Rubber Trailer Bumper # D3-96 does not require a steel mounting strip in the inside to install.
This bumper has pre-drilled holes and all you need to do is use 9/16" bolts to bolt it onto the rear of your trailer and you are good to go.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 3" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- 3 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: Size of Hole Saw to Use to Install the Recessed Trailer D-Ring Tie Down RR5K
- Q&A: Recommended Replacement Hub Assemblies for a Trailex Trailer with a 8 inch Wheel with 4 Bolts
- Q&A: Can I Charge My Trailer Battery Using 7-Way Trailer Connector on Truck
- Q&A: Can RV Covers Be Left On Travel Trailer While Driving
- Q&A: What is Max Safe Tire Temperature
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Replacement Automotive Lighting
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)