Pipe Diameter Compatible with Valterra Replacement Cap A04-0448BK

Question

Question:

Will cap and bracket fit over traditional 4” ABS plumbing pipe which, I believe, has a 41/2” OD?

asked by: Brenden

0

Expert Reply:

The Valterra Replacement Cap # A04-0448BK has an inside diameter of 4-3/4-inches. I measured one to confirm. So the pipe it will fit properly will have an outside diameter of approximately this same size.

expert reply by: Adam R

0

click to enlarge

Answer 1

The Replacement Cap and Saddle for Valterra Adjustable Sewer Hose Carrier - Black - Qty 1 #A04-0448BK you need for your Valterra Sewer Hose Carrier are just slid on the carrier and held on by friction. To get them off you will just need to hold the…

view full answer...

Answer 2

The inner diameter of the #A04-5094BK is 4-1/2 inches. This is the diameter of available space for storage.

view full answer...

Answer 3

The Valterra Replacement Cap #A04-0448BK has an inside diameter of 4-3/4-inches. We measured one to confirm. So the pipe it will fit properly will have an outside diameter of approximately this same size.

view full answer...

Answer 4

We have the part #A04-5094BK which is an adjustable RV sewer hose carrier that can be used at 50 to 94 inches in length but it comes with it's own end caps.

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…

view full answer...

Answer 11

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Pipe Diameter Compatible with Valterra Replacement Cap A04-0448BK

Product Page this Question was Asked From

Continue Researching