What Does C on Display of Prodigy P2 Brake Controller Indicate
Question:
Nissan Titan XD trailer brake shows c with trailer connected. I can adjust gain and apply brakes manually with good success. Then it displays c again. Am I in peril of not being able to brake?
asked by: Blake A
Expert Reply:
Sounds like your Prodigy P2 part # 90885 is wired up and functioning correctly. C on the display just means that a trailer connection is sensed. What happens when you touch the brakes? The display should jump to the level of braking it's applying to your trailer. If not, you have an issue with the red wire of the controller not being attached to a circuit that sees 12 volts only when the brakes are applied.
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Q&A: What is the Estimated Installation Time for Firestone Ride-Rite Air Bags on a 2006 Ford F-250
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)