Where Does Clip for Breakaway Kit Connect to for Hydraulic Actuator
Question:
where do u clip the cable ?
asked by: Donna H
0
Expert Reply:
The cable that comes on the Demco Hydraulic Trailer Brake Actuator # DM72VR is the breakaway kit. Since this is intended to activate the brakes on your trailer in the event that the trailer becomes uncoupled you will want to attached the clip at the end of the cable to one of the safety chain loops on your trailer hitch.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Bolt-On
- 7000 lbs GTW
- 2 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Demco
more information >
Continue Researching
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Q&A: Replacement Surge Brake Actuator For Atwood 85736 That Is Discontinued
- Q&A: Replacement Surge Brake Actuator For Atwood 61101
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Article: Most Popular Wheel Bearings
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)