Timbren Rear Axle Jounce Spring Kit for 2006 Honda Odyssey
Question:
Do the css-1168 coil sumo springs fit on both the front and rear springs, or are there different part numbers? Is the css-1168R different from the css-1168?
asked by: David K
Expert Reply:
The SumoSprings Coil Helper Spring kits # CSS-1168 and # CSS-1168R that you found on our site are actually the same product. The R designation that we use on the one kit refers to an application on the REAR coil springs on a 2006 Honda Odyssey like yours. SumoSprings has not tested the springs on the front coils of your vehicle.
For the 2006 Odyssey only rear axle kits are available since on this vehicle the low-slung rear suspension is most often where support is needed. The SumoSprings are a fairly easy installation suitable for a DIY-er with appropriate floor jack, jack stands and wheel chocks.
Better rear suspension leveling support will come from the Timbren kit # THROD2 since this kit uses stiffer patented natural rubber springs. This kit is a no-drill bolt-on install, but it is recommended for professional installation in a shop that has a vehicle lift.
Products Referenced in This Question
Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Front or Rear Axle
- Vehicle Suspension
- Front Axle Suspension Enhancement
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Standard Duty
- SuperSprings Intl
more information >
Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Rear Axle
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Standard Duty
- SuperSprings Intl
more information >
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Standard Duty
- Timbren
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Water Heater Anode Rod For Suburban SW6D
- Shop: Suspension Enhancement
- Shop: Timbren Rear Suspension Enhancement System
- Q&A: Complete Setup For Towing A 3,500lb Trailer With A 2008 Honda Odyssey
- Shop: Trailer Hitch
- Q&A: How to Reduce Sag While Towing with a 2006 Honda Odyssey
- Q&A: Rear Helper Springs for a 2008 Honda Odyssey with a Wheelchair Lift
- Shop: Replacement Head for Curt MV Weight Distribution Systems
- Shop: Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Front Axle
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Firestone Coil-Rite Air Helper Springs - Rear Axle
- Video: SuperSprings Coil SumoSprings Front Axle Helper Springs Review
- Video: Air Lift AirLift 1000 Air Helper Springs Installation - 2013 Honda Odyssey
- Video: Air Lift AirLift 1000 Air Helper Springs Installation - 2014 Honda Odyssey
- Video: Timbren Rear Suspension Enhancement Installation - 2016 Honda Odyssey
- Video: SuperSprings Coil SumoSprings Front Helper Springs Installation - 2018 Chevrolet Silverado 1500
- Video: Review of CURT Replacement MV Weight Distribution Head - C17075
- Video: Choosing the Right Trailer Wiring
- Search Results: 44649
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Search Results: 68149
- Article: Trailer Wiring Diagrams
- Search Results: 25580
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles