Dimensions of License Plate Screws and Hardware Kit
Question:
What is the diameter of this bolts?CR80230 I bought another one which diameter is 1/4 and it was too big. It did not fit the hole. 2016 Lexus ES350 Thank you very much!
asked by: Kazu
0
Expert Reply:
The Steel Fasteners for License Plates and License Plate Frames - Standard - Qty 4 # CR80230 are 1/4 inch diameter by 3/4 inch long. This is the standard diameter for license plate hardware, so if you have a smaller hole, you may want to consider enlarging it for compatibility or using stainless or zinc plated screws from a hardware store that will fit the current holes.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Steel Fasteners for License Plates and License Plate Frames - Standard - Qty 4
- Accessories and Parts
- License Plates and Frames
- Fasteners
- Non-Locking
- Standard
- Cruiser
more information >
Continue Researching
- Q&A: Replacement Spring Kit for Power Gear Jack on 2003 Fleetwood Southwind 37U
- Q&A: Replacement Radio for Furrion RV Stereo DV1200
- Q&A: Help Picking Out Replacement Hub for TDE 11033
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Q&A: Hole Size Needed for Cruiser CR80230 License Plate Mounting Hardware
- Q&A: Resetting the Pin on the LCI Leveling System Remote Control
- Q&A: Replacement Oil Bath Seal Recommendation for Dexter 12k Axle
- Article: How to Measure a Trailer Axle
- Article: Most Popular Wheel Bearings
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Wiring Diagrams