Which Wire from 7-Way Connector Gets Ran to Brake Controller
Question:
Ok do I leave the harness from controller to connector near emergency brake still plugged in? Then splice in the blue wire at p3 controller?
asked by: Vincent S
0
Expert Reply:
It's actually the blue wire of your 7-way that you'll need to run up to the brake controller to make it active. You'd run this wire to the blue wire of the controller and as long as the controller is wired up the rest of the way you'd be in business. You'll want to use 10 gauge wire like part # 10-1-1 (sold by the foot).
I attached a picture that shows how a brake controller normally wires up to a vehicle and 7-way.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
Vincent S.
1/25/2019
Ok do I leave the harness from controller to connector near emergency brake still plugged in? Then splice in the blue wire at p3 controller?