Can the Demco Hijacker 8550034 be Used with an Under Bed Mount Kit on a 2019 Chevy Silverado 3500

Question

Question:

I was hoping to do an under bed system maybe the 4 pick system like Ford with the 8550034 ?? Can you help?

asked by: Mark

0

Expert Reply:

Absolutely, the Demco Hijacker Autoslide 5th Wheel Trailer Hitch part # DM8550034 is for above bed mounting rails. However, you can make it compatible with the underbed mounting kit for your 2019 Chevrolet Silverado 3500 which is the Underbed Rail and Installation Kit for Demco Hijacker part # DM8551010 by obtaining the Replacement Side Plates for Demco Hijacker Autoslide 5th Wheel Trailer Hitches part # DM6004.

I also recommend that you purchase an in-bed 7-way like the Demco 5th Wheel/Gooseneck 90-Degree Wiring Harness part # DM8555002 if you don't already have one. I have attached an install video of the under bed mounting kit for you as well.

expert reply by: Conner L

0

Answer 1

Your factory OEM 5th Wheel Towing Prep Package should be setup with the 21,000 lb, model DM8550037. If this is the case the Replacement Side Plates for Demco Hijacker Autoslide 5th Wheel Trailer Hitches - Underbed Mount, part #DM6004, will work with…

view full answer...

Answer 2

On your 2022 Chevy Silverado 2500 with a 6-3/4 ft. bed without OEM prep, I recommend the Demco Hijacker #DM8550022 (18k) or #DM8550037 (21k). The great thing about the Hijacker is its autoslide function that takes away the pain and inconvenience that…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 10

Generally speaking, the lube plate will need to cover the skid plate on the 5th wheel hitch. There are some pin boxes out there that will recommend a specific lube plate but most of the times this classification will be from the 5th wheel hitch…

view full answer...

Answer 11

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Can the Demco Hijacker 8550034 be Used with an Under Bed Mount Kit on a 2019 Chevy Silverado 3500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching