Choosing a Weight Distribution System for a 2006 Toyota Sequoia
Question:
First, I checked out your recommended WD Hitches for a 2006 Toyota Sequoia. Why are most of them 10,000 lbs or over when the Sequoia is only rated at a max towing capacity of 6,500 lbs? This brings up my principle question. What happens if your hitch is rated for a tongue weight significantly higher than your actual tongue weight. The trailer that my Sequoia will be pulling is 3,200 lbs empty with a tongue weight of 336 lbs. I am looking at a Curt WD hitch that has tongue rating of 600 lbs and a friend of mine gave me a band new sway bar kit. I can correct any sagging with the air bag suspension but I understand that the air bags cannot help in distributing the weight. Can I, or do I need to, purchase a WD Hitch and is it a problem if it is higher rated than my tongue weight?
asked by: Todd
Expert Reply:
In regards to selecting the correct weight distribution system, the loaded tongue weight of the trailer is not the only figure that goes into this. The weight of any cargo stored behind the rear axle of the tow vehicle needs to be added in as well. Also, the systems are for a range of total tongue weights with the first number you see usually being the max. Therefore, the 10,000 lb systems you are seeing most likely have a weight range of 6,000 to 10,000 lbs which is suitable for your Sequoia. We always recommend going a bit over what you think your total tongue weight is to allow for some room for error.
In regards to the diffrence between your trailer hitch and tow vehicle, the tongue/trailer weight rating of a trailer hitch and the tongue/trailer weight rating of a vehicle are tested separately of one another which is why you see two different figures. The towing capacity of your setup is always going to be limited by its weakest component. The Curt Trailer Hitch Receiver part # 13440 which is a fit for your 2006 Toyota Sequoia has a 6,500 lb max gross trailer weight rating and a 650 lb max tongue weight rating (when used with a weight distribution system) whereas your Sequoia has a 6,200-6,500 lb max gross trailer weight rating and a 620-650 lb max tongue weight rating.
In regards to selecting the correct suspension enhancements, a weight distribution system is going to be your best option. For this, I recommend the Curt Short-Arm Weight Distribution System part # C17341 with the Curt 2" Hitch Ball part # A-90 which will be perfect for your trailer as it has some room for error. It will also work with the friction sway control bar you got from your friend. When using this system with airbags like the Air Lift AirLift 1000 Air Helper Springs part # AL60812 you will want to set the airbags first and then engage the spring bars.
I have attached review/install videos for you as well.
Products Referenced in This Question
2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-5/8 Inch Shank Length
- 1-1/4 Inch Diameter Shank
- 10000 lbs GTW
- Class IV
- Class V
- CURT
more information >
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Air Springs
- Light Duty
- Air Lift
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6500 lbs WD GTW
- 2 Inch Hitch
- 650 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Trailer Brake Controller Installation - 2008 Toyota Sequoia
- Shop: Reese Pro Round Bar Weight Distribution w Sway Control - Round Bar - 8,000 lbs GTW, 800 lbs TW
- Shop: Reese Dual Cam High-Performance Sway Control for Steel Trailer Frames
- Shop: Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Toyota and Lexus
- Shop: Reese Weight Distribution System w Shank - Trunnion Bar - 8,000 lbs GTW, 800 lbs TW
- Search Results: brake controller
- Q&A: Do the Links of a Weight Distribution System Represent Tongue Weight
- Video: Reese Friction Sway Control Kit Review
- Search Results: fastway e2
- Shop: Trailer Hitch
- Shop: Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: Choosing the Right Trailer Wiring
- Search Results: 44649
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 68149
- Video: Choosing the Right Brake Controller
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 25580
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Search Results: dust cap
- Shop: Fifth Wheel Hitch
- Article: Brake Controller Installation: Starting from Scratch
on Trailer Hitch
