Could Backup Camera Activate with Brake Pedal
Question:
can i run my back up camera to my reves light and i want to put it on my break light so when i stop i would show me how fall pepole are and just want to know if i ran a 2 wire to it would it work so that way it work when i back up and when i stop it can come on thanks
asked by: TIMOTHY V
Helpful Expert Reply:
If you wanted to wire up a backup camera to come on every time you put on the brakes it's definitely possible to do that and have it come on when you are in reverse. It might get somewhat annoying at night with the monitor coming off and on but it would just be a matter of running the two wires to the same circuit like you mentioned.
Product Page this Question was Asked From
Rear View Safety Backup Camera System - 2 Camera Setup
- RV Camera System
- Backup Camera
- Distance Grid Lines
- Mirrored Image
- Night Vision
- Hardwired
- 130 Degrees
- Dashboard Pedestal Mount
- Below Rear Clearance
- 7 Inch Display
- 2 Cameras
- Rear View Safety
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement For Fan-Tastic Roof Vent FV6300
- Q&A: Tray Clearance For The MORryde Refrigerator Tray # MR59RR
- Q&A: Troubleshooting No Power to RVS Camera System
- Q&A: Rearview Safety Backup Camera Kit Recommendation with Quick Disconnects for Use with Trailer
- Q&A: Best Suspension Upgrade Options for a 2014 Fleetwood Bounder Motorhome
- Q&A: Product Comparison Of MORryder Scissor Jack Cross Brace And JTs Strong Arm Jack Stabilizer Kit
- Q&A: How are Cameras of Rear View Safety Backup Camera System - 2 Camera Setup Wired
- Article: Trailer Jacks
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Bike Racks for Electric Bikes
- Article: How to Charge a Dump Trailer Battery
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation: Starting from Scratch