Does Draw Tite Hitch for 2018 Ram 1500 Require Trimming Fascia
Question:
Sorry if I missed this but. Do you have a Class III front hitch for a 2018 Ram 1500 Limited, 4WD that can be installed without any mods to the front end other than drilling for the mount? Thanks very much.
asked by: Mike S
Expert Reply:
All of the front hitches we offer for your 2018 Ram 1500 like the Draw Tite part # 65062 do require trimming of the front fascia. The trimming allows the hitch to sit a little bit higher so that you get slightly better ground clearance. Front hitches typically aren't classified but this hitch is a 2 inch size like a Class III normally is and has higher capacities too at 9,000 lb line pull and 500 lb vertical load.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Checking Electric Trailer Brake Magnets for Wear, Shorts, Amperage, and Resistance
- Q&A: Why Would New Trailer Brakes Feel Weak After Axle Replace
- Q&A: Replacement Trailer Clearance Light for PM150
- Q&A: Determining Axle Length for Home-made 4 x 8 Trailer Using Square Stub Spindles
- Q&A: Wet Shackle Bolts to Reduce Noise from Tandem Axle Travel Trailer Suspension
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Measure for Trailer Hitch Drop
- Article: RV Cell Boosters, How Do They Work?
- Article: My Trailer Hitch Doesn't Fit
- Article: Stability Control for Heavy Duty Vehicles
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)