Replacement Extang Express Cover for a 2003 Chevrolet Silverado 1500/2500 with the 6-1/2 Foot Bed

Question

Question:

I have the express tonno by Extang cover and would like to replace the cover , not sure the model ,locks in back ,with Velcro, and a slanted rail

asked by: Enrest

0

Expert Reply:

The correct replacement cover for the Extang Express Soft Tonneau Cover part # EX50940 on your 2003 Chevrolet Silverado 1500/2500 with the 6-1/2' bed is the Replacement Tarp for Extang Express Roll-Up Soft Tonneau Cover part # EX49940.

expert reply by: Conner L

0

Answer 1

The correct replacement cover for your Extang Express Soft Tonneau Cover #EX50940, which is no longer available, is the Replacement Tarp for Extang Express Roll-Up Soft Tonneau Cover #EX49940.

view full answer...

Answer 2

Thank you for all of the info! The cover you have on your 2003 Chevy Silverado 2500HD long bed is part EX14945 which means your replacement tarp is part #EX13945 on our site. I confirmed this with my contact at Extang.

view full answer...

Answer 3

I am happy to determine the replacement cover for you but I would need the serial number off of your older Extang cover. The easiest way is to locate the serial number. Most of the time the serial number can be found on the driver's side front…

view full answer...

Answer 4

The Replacement Tarp #EX1945 fits the Extang BlackMax Snap-On Soft Tonneau Cover 2945.

view full answer...

Answer 5

The tarp you have now is the Extang Classic Platinum Soft Tonneau Cover 7945. The correct replacement is the Replacement Tarp for Extang Classic Platinum Roll-up Soft Tonneau Cover - Black #EX6945.

view full answer...

Answer 6

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 7

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Replacement Extang Express Cover for a 2003 Chevrolet Silverado 1500/2500 with the 6-1/2 Foot Bed

Product Page this Question was Asked From

Continue Researching