How to Manually Crank Lippert Components High-Speed Power Stabilizer Jack LC298707

Question

Question:

jacks are up and work together want them down turn right or left got handle

asked by: Shorty S

1

Helpful Expert Reply:

To manually lower the Lippert Components High-Speed Power Stabilizer Jack # LC298707 you will want to turn the crank handle counter-clockwise. Turn it clockwise to raise the legs.

Lippert cautions to disconnect the stabilizer from the battery before manually operating the crank. Failure to disconnect the battery can cause electricity to back feed through the motor and cause serious damage to the system as well as void the Limited Warranty.

expert reply by: Adam R

1

Answer 1

I attached a picture that I got from Lippert that shows the wiring diagram for their stabilizer jacks like the part #LC298707.

view full answer...

Answer 2

It sounds like you have a short on the wiring for your Lippert Stabilizer Jack, like part #LC298707. I spoke with my contact at Lippert who said that the wires on the switch for the extend/retract operations are likely touching which is causing your…

view full answer...

Answer 3

Yes, the Lippert Components Power Stabilizer Trailer Jack #LC298707 that you referenced does include the switch and breakers needed to complete the install.

view full answer...

Answer 4

It sounds like you have got a good start on the troubleshooting. The next step would be to check the motor. I recommend using an alternate source to power the motor. If the motor still isn't working then it will need to be replaced. In order to…

view full answer...

Answer 5

Thanks for the photo, and I searched but could not find anything with the numbers on the sticker. Truly, the only way to know which is the correct replacement is to know the model of your Lippert stabilizer jack. There are only a couple that are…

view full answer...

Answer 6

When troubleshooting the stabilizer jacks like the Lippert High-Speed Power Stabilizer Jack #LC298707 the manufacturer provides a few options for what to check when the system is not responding to the switches. Low Voltage: - Test battery voltage…

view full answer...

Answer 7

I do have ideas concerning your Lippert 113407 not being able to retract, and I recommend starting by checking your ground wiring to ensure it is bare metal without dirt or corrosion. A poor ground can lead to a drop in power which would be why the…

view full answer...

Answer 8

If you have a stabilizer system like Lippert High-Speed Power Stabilizer Jack #LC298707, then you should be able to check out the attached wiring diagram to verify where the fuse and breaker should be. The breaker is inline of the red wire in between…

view full answer...

Answer 9

To extend/retract the Lippert High-Speed Power Stabilizer Jack #LC298707 you will need to press and hold the the switch, as there is no automatic cut off. However, this jack does have an integrated circuit breaker to protect you from damaging your RV…

view full answer...

Answer 10

If the breaker is resetting that means the motor is wanting to draw too much amperage. Since you've replaced the switch already you've narrowed it down to that. For the replacement motor you'd then want the part #LC352338. This is an…

view full answer...

Answer 11

If the motors on your Lippert High-Speed Power Stabilizer Jack #LC298707 do not work when you use the switch you will want to determine if you have a bad switch or if the jack is not getting power from the battery on your camper. First you will want…

view full answer...

Answer 12

In order to manually retract the legs on the Lippert Components High-Speed Power Stabilizer Jack part #LC298707 you will first need to obtain the Replacement Manual Crank Handle part #LC119226. Once you have this tool you will then need to insert it…

view full answer...

How to Manually Crank Lippert Components High-Speed Power Stabilizer Jack LC298707

Product Page this Question was Asked From

Continue Researching