SuperSprings Slide Forward on Leaf Spring Pack

Question

Question:

Had installation done yesterday on 2015 Nissan Frontier SV. After driving home from the retail shop, noticed the drivers side rear shackle roller was behind the first factory leaf end, resting on the second. The passengers side rear shackle roller remained on the first factory leaf. See pics. Is this a common situation with super springs?

asked by: Ed

1

Helpful Expert Reply:

It sounds like the hold down clamp (see photo) has loosened which has then allowed the SuperSprings Suspension Stabilizer and Sway Control Kit part # SSA1MTKT to shift forward on your 2015 Nissan Frontier. In order to fix this you will want to loosen the two nuts at the bottom of the clamp and then shift the spring back into position while tightening the nuts back down. This should keep the spring in place but if it does not please let me know and I would be happy to let you know what options you have. I would apply more torque to the nuts then previously used during the original install.

expert reply by: Conner L

1

click to enlarge

Answer 1

I will first start out by addressing the additional transmission cooler you will want to help keep the transmission fluid temperatures at a safe level, while towing a 5,000 lb. trailer with your 2011 Nissan Frontier. As you mentioned, your Frontier…

view full answer...

Answer 2

Ultimately air bags are best when it comes to adjusting for different loads for your Nissan Frontier since they actually have the ability to be adjusted, but they are more expensive and require maintenance which is why the SumoSprings are so…

view full answer...

Answer 3

In regards to suspension enhancements for a 2018 Nissan Frontier, you have a few options but there are none from SuperSprings. The best option for unloaded ride quality would be the Firestone Ride-Rite Air Helper Springs part #F2558. However, if you…

view full answer...

Answer 4

The lip is supposed to be there. It appears to be a way to allow the bracket to set more level than what the frame of the truck allows since it is angled and not parallel to the ground.

view full answer...

Answer 5

Firestone Ride-Rite air bags, #F2558, will fit your 2005 Nissan Frontier NISMO. There are Firestone models that will not fit the NISMO edition because of the placement of some brake lines that would block where the brackets for those kits would go…

view full answer...

Answer 6

The SuperSprings Custom Suspension Stabilizer #SSA1MTKT are not intended to increase the height of your 2007 Nissan Frontier. The stabilizer is meant to provide more support for your vehicle when carrying heavy loads in the cargo area or towing a…

view full answer...

Answer 7

The suspension travel on your 2018 Nissan Frontier SV will not be great enough to create any issues for the Firestone Ride-Rite Air Helper Springs part #F2558 which are a confirmed fit. You are also correct that the Daystar Cradles are used mainly…

view full answer...

Answer 8

I do have an option but I just checked with Super Springs, the manufacturer of SumoSprings and they do not offer any kits for a 2018 Nissan Frontier. Instead, I recommend the Timbren Rear Suspension Enhancement System part #TTORTUN4L. The Timbren…

view full answer...

Answer 9

That's an interesting question, and yes, a dual-path compressor like the Firestone Air Command #F2178 can allow air to transfer from one side to the other in a turn. Its function is to allow you to level the air bags to different pressures for…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

SuperSprings Slide Forward on Leaf Spring Pack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching