Recommended Suspension System for Older EZ Loader Trailer
Question:
I need an axle... Its on a 1972 ezload trailer. The axle measures from outside of hub to outside of hub at 67 inches. The springs mount above the axle and are 48.75 inches apart. It also bends down 4 inches on the ends of the axle. It also has a 24 inch set of springs that are 1.75 inches wide. Has 5 on 4.5 hubs the ones on it are tapered. No breaks. Is this even a possibility of getting?
asked by: Jeremy D
Expert Reply:
That type of axle is possible to get though you may need to have it custom-fabricated as we do not offer one with those dimensions.
One possibility to consider is a Timbren Axle-Less Suspension System so you would not need an axle at all. You will need to know your EZ-Loader's GVWR for this; for example the Timbren Axle-Less Trailer Suspension System # ASR3500S06 has a 3,500 capacity and uses EZ-Lube spindles with a 4" lift.
With this system you would then use Idler Hubs # 84545UC1-EZ which are for use with EZ-Lube spindles and have a 5 on 4-1/2" bolt pattern.
Products Referenced in This Question
Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub
- EZ Lube
- Pre-Greased
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Timbren Axle-Less Trailer Suspension - Standard Duty - 4" Lift - 4 Bolt Flange - 3,500 lbs
- Trailer Axles
- Rubber Spring Suspension
- Easy Lube Spindles
- No Hubs
- 3500 lbs
- Spindles Only
- Universal Fit
- Lift - 4 Inch
- Timbren
more information >
Product Page this Question was Asked From
Dexter Trailer Axle w/ Electric Brakes - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Spindles
- Electric Brakes
- 3500 lbs
- 5 on 4-1/2 Inch
- 74 Inch Long
- 89 Inch Long
- No Drop or Lift
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current
- Article: How to Measure a Trailer Axle
- Q&A: How Thick are the Aluminum Tandem Axle Trailer Fenders # HP52VR?
- Q&A: Correct Tankless Water Heater Replacement for Atwood 6 Gallon 16" x 12"
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: How to Measure Trailer Leaf Spring to Find Correct Replacement
- Q&A: Are There Rust-Proof Trailer Fenders For 15 Inch Wheels For Tandem Axle Trailers
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Q&A: Locating Replacement Dexter P-15 Axle on Trailer