Replacement 12V Fan Motor Assembly for Fan-Tastic Vent Roof Vent Model 1000
Question:
Will this fit model 1000 Thank you
asked by: Dave
Expert Reply:
Fan-Tastic Vent Roof Vent Replacement 12-Volt Fan Motor Assembly # FVK8017-00 will fit many current and discontinued vent models. You can compare the dimensions of this replacement item, shown in the photo I included for you, to see if they match your vent.
Overall width of the "bow tie" bracket is 12-5/8-inches; diameter of the circular fan blade is 11-3/8-inches; the four mounting holes are spaced apart 5-15/16 x 11-1/16-inches.
My contact at Fan-Tastic Vent advised that they did not produce a model 1000 but so long as the dimensions match the part above will work.
Product Page this Question was Asked From
Replacement Fan Motor Assembly Kit for Dometic FanTastic Roof Vent Fans
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Motor Parts
- Motor
- Dometic
more information >
Continue Researching
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Trailer Hitch for a 2015 Honda Pilot
- Q&A: Parts Needed to Tow a Trailer with a 2015 Honda Pilot
- Q&A: Installation of Hitch on Fifth Wheel Trailer
- Q&A: When Flat Towing a Vehicle How Much Tongue Weight is on the Trailer Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Best Ladder Racks
- Article: Gooseneck to 5th Wheel Adapters
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Replace or Install an RV Roof Vent