Is There any Wiring Needed to Install Blue Ox Patriot Supplemental Braking System
Question:
What kind of wiring is involved in this system
asked by: Jim
1
Helpful Expert Reply:
There really isn't any wiring needed to install the Blue Ox Patriot supplemental braking system part # BLU37TR unless you have a towed vehicle that requires you to disconnect the battery when being flat towed. In that case you'd need to use an outlet kit part # RM-9332 wired to the vehicle battery to provide the power source.
I attached a link to the install instructions for this kit as well as an install video.
expert reply by:
Jameson C
1
Products Referenced in This Question
Product Page this Question was Asked From
Blue Ox Patriot Portable Flat Tow Brake System - Proportional
- Tow Bar Braking Systems
- Brake Systems
- Proportional System
- Recurring Set-Up
- Portable System
- Power Assist Brake Compatible
- Air Brakes
- Air Over Hydraulic Brakes
- Hydraulic Brakes
- Blue Ox
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Article: Trailer Wiring Diagrams
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: What is the Difference Between the Blue Ox Patriot BRK2019 & BRK2022?
- Article: Must-Have Flat Towing Components
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Comparing the Blue Ox Patriot 2 and Patriot BLU37TR Portable Braking Systems
- Article: Roadmaster Vehicle Specific Base Plates
- Article: How to Choose a High-Low Adapter
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)