Wiring Roadmaster Brake Light Switch Kit for SMI DUO and Coachlink
Question:
I think this has been asked already, but I need further clarification. I just ordered the SMI DUO, the Roadmaster brake light switch and the SMI coachlink 900 wireless transmitter. I have a 2003 jeep liberty limited. Watching the videos and reading the directions both the indicator light and the brake light relay attach to the cold side of the brake lite switch. So how do you wire both to the switch. Is there a wiring diagram for it? Thanks for your help...
asked by: Conrad R
Expert Reply:
To use the Roadmaster Stop Light Switch Kit # RM-751449 that you referenced for two circuits is not difficult at all. If you check out the picture I attached you'll see where to add the second wire to the butt connector so that the switch can work for both products you mentioned.
Products Referenced in This Question
Roadmaster Stop Light Switch Kit
- Tow Bar Braking Systems
- Stop Light Switch
- Roadmaster
more information >
Product Page this Question was Asked From
Demco Stay-IN-Play Duo Flat Tow Brake System for RVs w/ Hydraulic Brakes - Proportional
- Tow Bar Braking Systems
- Brake Systems
- Proportional System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Hydraulic Brakes
- Demco
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Brake Controller
- Video: Review of Roadmaster Tow Bar Braking Systems - Even Brake Braking Monitor - RM-9430
- Shop: Braking Monitor for Roadmaster Even Brake Flat Tow Brake System - Serial Numbers Up to 27,496
- Video: Review of Roadmaster Tow Bar Braking Systems - Even Brake Transmitter - RM-9420
- Shop: Replacement Transmitter for Roadmaster Even Brake Braking Monitor - Serial Numbers Up to 27,496
- Shop: Vehicle Tow Bar Brake System
- Shop: Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Shop: Trailer Wiring
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: rm~751449
- Shop: Redarc Tow-Pro Elite Brake Controller - Dash Knob - 2 Braking Modes - 1 to 3 Axles - Proportional
- Video: Roadmaster Stop Light Switch Kit Review RM-751200
- Q&A: Brake Controller Connector Location on a 2018 Jeep Cherokee Trailhawk with Factory Tow Package
- Video: Roadmaster Stop Light Switch Kit Installation - 2018 Jeep Cherokee
- Search Results: 751471
- Shop: Roadmaster Stop Light Switch Kit
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Q&A: 2019 Jeep Cherokee Trailhawk Trailer Brake Controller Installation
- Q&A: Wiring Configuration for Tekonsha Prodigy P3 Trailer Brake Controller 90195
- Article: Trailer Wiring Diagrams
- Shop: Base Plate for Tow Bar
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: Roadmaster Stop Light Switch Kit Installation - 2015 Jeep Grand Cherokee
- Search Results: stop light switch
- Shop: Windshield Covers
- Shop: Side Window Vents
- Q&A: Where Should The 12 Volt Wires Be Connected On A 7 Way To 6 Way Wire Connection?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Review of Roadmaster Tow Bar Braking Systems - Even Brake System - RM-9400