Replacement 12-1/4 Inch x 3-3/8 Inch Braking Assembly with Four Bolt Brake Mounting Flange

Question:

We are looking for a replacement electric brake assembly for a very old trailer. The AkeBRK-10 has the same measurements but the mounting of the plate is a four hole and the plate that it mounts too is a 4 hole square shape. Would this assembly mount up????

asked by: Doug B

Helpful Expert Reply:

If the braking assemblies you have now are indeed 12-1/4" x 3-3/8" and use a four bolt brake mounting flange then you are going to want to use the Electric Trailer Brake Kit w/ Dust Shields part # AKEBRK-8, not the Electric Trailer Brake Kit w/ Dust Shields part # AKEBRK-10.

I have attached a photo which shows the correct way to measure your braking assembles for replacement. You will also need to verify that the bolt holes on your brake mounting flange are 3-7/16" apart on center from side to side and 3-5/8" apart on center top to bottom.

I have attached a review video for you as well.

expert reply by: Conner L