Material of Brophy D-Ring Tie-Down Anchor
Question:
What material is the SR10-C made from? Im running an FEA and need to assign the density property.
asked by: Leah
0
Expert Reply:
That sounds ... complicated.
But to answer your question, the Brophy Light Duty D-Ring Tie-Down Anchor # SR10-C is made of zinc-plated steel according to the manufacturer.
I have also attached a photo showing the measurements of this d-ring for you to check out.
expert reply by:
Kyle S
0
click to enlarge
Product Page this Question was Asked From
Brophy Light Duty D-Ring Tie-Down Anchor - 2-1/4" Wide - Surface Mount - 330 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 330 lbs
- D-Ring
- Surface Mount - Bolt-On
- Brophy
more information >
Continue Researching
- Q&A: Recommended D-Rings For a 2019 Nissan NV200 SV Cargo Van
- Q&A: Will CE Smith Spare Tire Carrier for Trailers # CE22007Z-11050-2 Fit 1-1/2-Inch Trailer Frame
- Q&A: Spare Tire Carrier Recommendation for Kayak Carrier and 4 Bolt Spare
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Is There A Wall Mounting Bracket On The Back of the Furrion Convection Oven?
- Q&A: Replacement Lock for Sears X-Cargo Sport 20 Cargo Box
- Q&A: How To Keep Hitch Ball From Spinning When Torqueing Nut
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Best Camper Jacks
- Article: Cargo Tie-Down Methods
- Article: Basics of Tie-Down Anchors