Carrying Bikes on a 2003 Scion xA
Question:
I own a 2003 Scion Xa. My only purpose for buying the C11488 hitch is to use my bike carrier that has a 2inch . I am guessing I would need to buy the adapter piece to make this work.
asked by: James M
Expert Reply:
The Curt trailer hitch receiver, part # C11488, is confirmed to fit your 2003 Scion xA and is a Class I hitch with a 1-1/4 inch opening. This means you will need hitch adapter that expands to 2 inches in order to use your current bike rack. You need to know first that using an adapter does decrease your hitch's tongue weight capacity by 50 percent.
From my research your Scion isn't rated for towing at all so there really isn't a defined tongue weight. Check your owner's manual to see if it lists a rating. Either way it's going to be very low, maybe 100 pounds at the most if I had to guess, and the adapter is going to cut that down to 50 pounds, which likely isn't enough for a rack and bikes.
In my opinion your best bet is to replace your bike rack with a Class I rack so you can keep all of what tongue weight you have. I recommend the Kuat Beta, part # B202-114, because it weighs about 12-1/2 pounds itself.
Another option is to go with a trunk mount rack. A great option that fits your Scion is the Saris Bones, part # SA805BL for a 2-bike or # SA801BL for a 3-bike. This is also the only way to carry more than 2 bikes on the back of your vehicle since a Class I hitch is always limited to two bikes. This is also your most cost effective option.
Products Referenced in This Question
Kuat Beta Bike Rack for 2 Bikes - 1-1/4" Hitches - Tilting
- Hitch Bike Racks
- Hanging Rack
- Folding Rack
- Tilt-Away Rack
- Frame Mount
- Locks Not Included
- 2 Bikes
- Class 1
- Class 2
- Fits 1-1/4 Inch Hitch
- Kuat
more information >
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver
- Hitch Adapters
- Hitch Expander
- Bike Racks
- Cargo Carriers
- Hitch Mounted Accessories
- 7-1/4 Inch Extension
- Fits 1-1/4 Inch Hitch
- 1-1/4 Inch to 2 Inch
- Brophy
more information >
Saris Bones 3 Bike Rack - Trunk Mount - Adjustable Arms
- Trunk Bike Racks
- Frame Mount - Anti-Sway
- 3 Bikes
- Non-Retractable
- Locks Not Included
- Does Not Fit Spoilers
- 6 Straps
- Adjustable Arms
- Hanging Rack
- Saris
more information >
Saris Bones 2 Bike Rack - Trunk Mount - Adjustable Arms
- Trunk Bike Racks
- Frame Mount - Anti-Sway
- 2 Bikes
- Non-Retractable
- Locks Not Included
- Does Not Fit Spoilers
- 6 Straps
- Adjustable Arms
- Hanging Rack
- Saris
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Lid and Lift Arm for Dometic 810263
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Q&A: Recommended Replacement For An Innoflame RV42D80F-C1 Fireplace
- Q&A: Surge Coupler to Replace Older Atwood Model
- Q&A: Correct Replacement for Dexter Electric Trailer Brake Assemblies 023-476-00
- Q&A: How to Install a Brake Controller on a 2016 Jeep Cherokee
- Q&A: Finding the Cold Side of the Brake Light Switch in a 2017 Jeep Cherokee
- Article: My Trailer Hitch Doesn't Fit