Can the Stop Light Switch Wire on a 1989 Ford F-250 Be Used for a Brake Controller
Question:
I purchased a p3 brake controller from you folks a couple weeks ago. I plan to use it on a 1989 3/4 Ton Ford F250 with anti lock brakes. I have not had time to install it yet. I ran across this Generic information. Is this a valid concern for my application. SPECIAL INSTRUCTION FOR 1989-91 FORD E AND F SERIES TRUCKS AND VANS WITH ANTI-LOCK BRAKES - DO NOT CONNECT TO STOPLIGHT SWITCH ON THESE VEHICLES LIGHT GREEN WIRE TURN SIGNAL HARNESS CONNECTOR UNDER DASH NEAR STEERING COLUMN SPLICE STOPLIGHT WIRE TO LIGHT GREEN WIRE. Please advise. Thanks, Victor Stianchi.
asked by: Victor
Helpful Expert Reply:
I spoke to my contact at Tekonsha and they were aware of the issue you described however, this information only really applies to older brake controllers that draw a lot of power. The Tekonsha Prodigy P3 Trailer Brake Controller part # 90195 draws very little power from the vehicle's wiring and will work fine for you while hooking up to the stop light switch wire. If you do use an older brake controller that draws substantial power then you will just want to tap into the stop light switch wire further down in the wiring harness.
Please note that in order to find the correct stop light switch wire you will want to use a circuit tester.
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Q&A: 10k Dexter Replacement Hub for a 8-415