Where to Place Tandem Axle Slipper Springs on Trailer being Built
Question:
Im building a 24k with triple 3.5inch 8K under-sprung axles with 28inch slipper springs. the equalizers are 11.5 long, Mounts are 3.75 tall front spting is 4.5 and rear is 5. How can I figure out where to mount them on my 16+4 trailer. Also does the slip go towards the rear on all three in this case? Thank you
asked by: Rob
Expert Reply:
The slipper side of slipper leaf springs need to face the rear of the trailer.
To determine the location for the front and rear hangers on your tandem axle trailer you will first need to make sure that you have the correct center point for your equalizer hanger.
The center point of your equalizer hanger needs to be located where you will have 60 percent of the frame of the trailer in front of the center of the equalizer hanger and 40 percent behind the center of the equalizer hanger. For example, if the trailers frames length is 18 feet, then the center-line location for the equalizer hanger will be 10.8 feet from the front of the trailer and 7.2 feet from the back.
This is where to start with when picking out axle locations for a tandem axle trailer. You will need to determine the tongue weight of the trailer and then check out the picture I attached if the tongue weight is anything other than 10 percent of the total trailer weight.
Product Page this Question was Asked From
Triple-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front/Rear, 2-1/2" Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Triple Axle
- etrailer
more information >
Continue Researching
- Q&A: Is Bushing Required on Open Eye End of Slipper Spring
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: Recommended Leaf Springs and Equalizers for Triple Axle Trailer With Double Eye Springs
- Q&A: How to Determine Correct Replacement Slipper Springs
- Article: Slipper Spring Trailer Suspension System Review
- Shop: E-Z Flex Equalizers - Double-Eye Springs - Tandem Axle - 8,000 lbs - Qty 2
- Shop: Triple-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front/Rear, 2-1/2" Center
- Shop: Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 8,000 lbs
- Shop: Equa-Flex Cushioned Equalizers - Double Eye Springs - Tandem Axle - 5.2K
- Search Results: leaf spring
- Search Results: trailer shock absorbers
- Shop: Replacement Top
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 2-1/4" Long Shackle Straps
- Search Results: equalizer
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Hitch
- Video: MORryde Tandem Axle Trailer Suspension Upgrade Kit Installation
- Article: Trailer Wiring Diagrams
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Search Results: 25580
- Video: Dexter E-Z Flex Suspension Kit Review and Installation
- Article: How to Accurately Measure Trailer Leaf Springs
- Shop: Trailer Wiring
- Shop: Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs
- Video: etrailer Trailer Axle 4-Leaf Double-Eye Spring Installation
- Shop: Fifth Wheel Hitch
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps
- Search Results: 44649
- Article: How to Raise Your Travel Trailer Height
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR