Trailer Brake Lights and Running Lights Work but Turn Signals Do Not
Question:
Lights and brakes work but cant get any of the blinkers working.
asked by: Mike
Expert Reply:
On a trailer that uses a 4-Way wiring harness, the brake lights and turn signals are on the same circuit. So, it is strange that the signals are not working when the brake lights are. First, with the trailer not connected, check the connector on the tow vehicle using a circuit tester like # PTW2993. This is to make sure that a signal is coming through to the vehicle side trailer connector.
If a turn signal is not coming through there must be a problem with the vehicle wiring. Depending on the vehicle, it may need fuses or relays to make the wiring fully functional. Also, it may show a signal at the connector but when connected to the trailer, the power draw is too great and without those fuses or relays not all the lights will work.
Next, you can connect the trailer and test the wiring right behind the trailer side connector. If you are getting a signal at this point, work your way back towards the tail lights, testing the wiring along the way. You may find a break in the wiring that is causing intermittent failure.
If your trailer has 5 wires coming from the back of the plug rather than 4, you have what is called a wishbone harness. On this type of harness, the running light signal is split at the trailer connector. One wire goes to the left running light circuit, the other goes to the right. There should still be 1 wire for turn/brake for each side. If these wires were somehow attached to the lights incorrectly, then that could be the problem.
Also check the ground connection on the trailer. The main ground should be attached to a clean metal surface on the trailer frame. The lights should also be making contact with clean and corrosion free metal surfaces.
Products Referenced in This Question
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: How Does Lippert Components Spare Tire Winch with Offset Cable Crank Up and Down
- Q&A: How Does the Handle Work on the Lippert Components Spare Tire Winch 159056
- Q&A: How is Lippert Spare Tire Winch LC159056 Raised and Lowered
- Q&A: Does Lippert Spare Tire Winch Lock or Hold in Any Position?
- Q&A: Lippert Crank Handle for Lippert Spare Tire Winch Assembly
- Q&A: Inside Diameter of Replacement Crank Extension for Lippert Spare Tire Winch Assemblies
- Q&A: Can Bearing Buddy Bearing Protectors Be Over-Filled with Too Much Grease
- Article: Trailer Wiring Diagrams
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers