Why Would Vehicle Fuse Blow After Installing Trailer Battery
Question:
When I installed an empty battery on the trailer, the fuse on the car went off. What happens if I have a charged battery on the trailer, have the trailer connected to the car, and start using the electric winch on the trailer? Will the fuse go off again?
asked by: Samuel P
0
Expert Reply:
What fuse blew when you connected the battery? Most likely what happened is that there's a short somewhere on the 12 volt accessory circuit near where you wired in the battery since it happened after the battery install. I'd recommend going over the trailer area looking for any obvious signs of a short and fix as needed.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Adapter 4-Pole to 7-Pole and 4-Pole
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 4 Flat
- Plug and Lead
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: AxleTek Brake Assembly Recommendation for 8k Axles with 4 Bolt Mounting Pattern
- Article: Trailer Wiring Diagrams
- Q&A: Installing a Brake Controller and a 7-Way Trailer Connector on a 2005 Ford F-150 With Factory 4-Way
- Q&A: How to Add Tension to Solera Slide-Topper
- Q&A: Slide Topper Recommendation for Box Width of 90.5 Inches on Gulf Stream Vintage 23BHS
- Q&A: Replacement 7-Way Wiring Harness for 2005 Ford F-150 with Factory Tow Package
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Tire Sizing
- Q&A: What is the Fuse Rating and Power Wire Gauge Used for Trailer Wiring Harness # 118571
- Q&A: Which Bolt Locking Hitch Pin Can be Keyed to a 2014 GMC Sierra 1500
- Article: Brake Controller Installation: Starting from Scratch
- Article: Best Bike Racks for Electric Bikes
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them