Auto Level Error Code with Lippert Ground Control Leveling System for RV
Question:
My middle stabilizer legs wont deploy during the auto level and I get an auto level error code. Do you know what might cause this and how to remedy? Parked on a level, concrete pull-thru site.
asked by: CPT A
Expert Reply:
On the Lippert Ground Control 3.0 # LC358590 the error you are receiving indicates either a problem at the left front jack, a hall signal issue (open ground/short, or other malfunction) or an unexpected high amperage current stall (meaning the battery stopped providing power for some reason).
To clear the error you can either fix what is causing the error such as a loose or damaged wiring harness for the middle jacks and then try clearing the code.
Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin retracting. All of the jacks should fully retract and clear the error.
If that does not clear the error code disconnect all connectors to let the system power down completely for about 15 minutes. The re-connect and follow the procedure again if the error code reappears.
Products Referenced in This Question
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Q&A: Troubleshooting Lippert 6-Point Leveling System
- Q&A: Ground Control Troubleshoot
- Q&A: Error on Display After Jack Removed from Lippert Ground Control Leveling System
- Q&A: Troubleshooting/Resetting Jacks On A Lippert Ground Control 3.0 That Have A Rear Sensor Error
- Q&A: Troubleshooting Error Code of Left Front Jack on Lippert Ground Control Leveling System
- Q&A: Zero Point Calibration for Lippert Ground Control 3.0
- Q&A: Troubleshooting Lippert Ground Control Legs that are Retracted but Show Error Code Needing Retract
- Search Results: adult trike rack
- Shop: Hollywood Racks Destination Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Article: How to Choose a Bike Rack for a Sedan or Hatchback
- Shop: Trailer Hitch
- Search Results: 44649
- Shop: Trailer Wiring
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Grease Seals 10-36 (pair)
- Video: etrailer Class III Trailer Hitch Installation - 2024 Subaru Crosstrek
- Search Results: 68149
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Brake Controller
- Shop: etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: 25580
- Shop: Fifth Wheel Hitch
- Video: Draw-Tite Max-Frame Trailer Hitch Installation - 2019 Chevrolet Equinox
- Article: Trailer Wiring Diagrams
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Article: My Trailer Hitch Doesn't Fit