How Thick is Center Trailer Suspension Hanger # 115919
Question:
What is the thickness of this center hanger ?
asked by: Dustin
0
Expert Reply:
I measured the thickness of center hanger # 115919 using digital calipers. The steel used to make it is 0.36 inches thick. I have linked a video review of this hanger for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Center Hanger for Double-Eye Springs - 5-7/16" Tall - 3/4" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Double Eye Springs
- 3/4 Inch Diameter
- 5-7/16 Inch Tall
- Tandem Axle
- Triple Axle
- Redline
more information >
Continue Researching
- Q&A: Recommendations for Raising Trailer to Add Clearance for Larger Wheels
- Article: Trailer Wiring Diagrams
- Article: How to Raise Your Travel Trailer Height
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Can 3-1/8 Inch Shackle Straps of MORryde Suspension Upgrade Kit Replace 3-1/4 Inch Shackle Straps
- Article: Where to Position the Trailer Axle?
- Q&A: 6,000 lbs Replacement Axle for a 2011 Keystone Montana
- Q&A: How Many MORryde X-Factor Crossmember Supports Are Needed For A Tandem Axle Trailer?
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Recommended 7000lb Leaf Springs To Replace Dexter 072-027-00
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Nev-R-Lube Trailer Bearings Cannot be Replaced with Regular Bearings
- Article: Double-Eye Trailer Suspension System Review
- Article: Dielectric Grease Review