Do Bearings Still Need to be Greased Before Installing Oil Bath Kit?
Question:
Do I grease bearings before install when using the oil bath kit? Thanks
asked by: Bob
0
Expert Reply:
No you should not grease your bearings before installing the Kodiak XL ProLube Kit # XLPROLUBE2440KIT to convert your hubs from grease to oil. This kit fits 5,200 lb and 6,000 lb axles and comes with 2 oil caps, 2 seals and an 8 oz. bottle of oil.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Kodiak XL ProLube Kit for for 5,200-lb to 6,000-lb Axles
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- 2.440 Inch
- Kodiak
more information >
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What Is The Recommended Lug Nut Torque On 7,000lb Axles?
- Q&A: Replacement Multi-Function LED Trailer Light for Glo-Brite 9852-88
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Front Door Lock Assembly Replacement for Keystone Montana 5th Wheel
- Q&A: LCI Leveling System Troubleshooting
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Charge a Dump Trailer Battery
- Article: Trailer Maintenance Schedule
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Brake Controller Installation: Starting from Scratch