Is the EZ5 Base Plate Kit RM-521424-5 on a 1999 Jeep Wrangler TJ Compatible with Falcon 2 RM-520
Question:
I currently tow a 2011 Honda Fit using a Falcon 2 tow bar. However, I plan to start towing a 1999 Jeep Wrangler TJ. Will base plate RM-521424-5 work with my tow bar? Will I need a cross bar and if I do, will I be able to use my current one from my Honds Fit? I know Ill need lights, I plan to use the same Brake Buddy and safety chains I currently use but will purchase a new break away switch. Is there anything else Ill need? Thanks
asked by: Rick
Helpful Expert Reply:
The Roadmaster EZ5 Base Plate Kit # RM-521424-5 is compatible with your 1999 Jeep TJ if it has a double tube bumper or a U-channel bumper and it does not have front leaf springs. If you have the Falcon 2 Tow Bar # RM-520 then they are compatible and you won't need an adapter.
For a complete flat towing setup you will need a base plate kit, tow bar, safety cables, vehicle tow bar wiring, a supplemental braking system, and possibly a high-low adapter. Since we already have the base plate kit, tow bar, safety cables, and braking system taken care of that just leaves wiring and a high-low adapter.
I like to recommend the Flexo-Coil Wiring Kit # RM-15267 because after the initial installation it is just plug-n-play before towing. You may also want to install the Charge Line Kit # RM-156-25 from your battery to the middle pin so that your battery will be charged while you are towing.
Most flat towing setups require a high-low adapter for the tow bar to remain level while towing. I have linked our selection of adapters as well as a helpful article that will help you determine which is the best one for your application for you to check out.
Attached are some installation instructions and videos for you to reference. It is always best to check your owner's manual as well for any specific instructions regarding flat towing.
Products Referenced in This Question
Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Roadmaster Battery Charge Line Kit for Towed Vehicles
- Accessories and Parts
- Tow Bar Wiring
- Battery Charge Line Kit
- Roadmaster
more information >
Roadmaster Falcon 2 Tow Bar - RV Mount - 2" Hitch - 6,000 lbs
- Tow Bar
- Hitch Mount Style
- Telescoping
- Steel
- 6000 lbs
- Fits Roadmaster Base Plates - Crossbar
- Fits Roadmaster Base Plates - Direct Connect
- Stores on RV
- Standard
- Roadmaster
more information >
Product Page this Question was Asked From
Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Base Plates
- Removable Drawbars
- Twist Lock Attachment
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Where Does the RoadMaster Base Plate # RM-521424-5 Install Below Bumper on a 2004 Jeep TJ?
- Q&A: Coupler Lock Recommendation for a Bulldog A-Frame Coupler 44150WH301
- Q&A: Best Parts to Flat Tow a Jeep Wrangler TJ with D-Ring Adapters
- Q&A: Will The Buyers Products RV Side Camera Fit a 2014 Newmar Dutchstar 4369?
- Q&A: 10 Foot Long Carpeted Bunk Boards for Boat Trailer
- Q&A: Complete Flat Tow Parts List For A 2006 Jeep Wrangler
- Q&A: Parts Needed to Flat Tow a 2001 Jeep Wrangler with Manual Transmission
- Article: Flat Towing Package for 1997 Jeep Wrangler
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Base Plate Adapter Table
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: RV Sway Control, Stabilization, and Suspension Enhancement