Is Fulton F2 Trailer Jack # F1413250334 Appropiate for A-Frame Car Hauler
Question:
I have a car trailer with an A-frame jack. According to fulton , I need a f2 A frame jack 1413250334 and the wheel is 500265. Can you tell me if this is correct and how much can you sell me one for?
asked by: Todd A
Expert Reply:
I can't answer that for certain without the weight of your trailer or dimensions of your current jack but it sounds appropriate. You need a jack rated high enough to hold the trailer when it's loaded and the 2,000 pound rated Fulton F2, part # F1413250334, with the wheel, part # F500266, is probably enough. You only need the jack to hold the trailer's tongue weight which is likely fairly high when loaded by not too high for this setup. Since the wheel is rated lower than the jack your lift capacity is limited by it at 1,600 pounds.
If your loaded tongue weight is higher, or considerably lower, let me know and I'll make a more specific recommendation. You should also compare the F2's lift of 9 inches to your current jack's lift to see how similar they are.
Products Referenced in This Question
Fulton F2 Adjustable A-Frame Jack - Sidewind - 9" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- 9 Inch Lift
- Bolt-On
- No Wheel or Foot
- Fulton
more information >
Wide-Track Wheel Assembly for Fulton F2 Adjustable A-Frame Jack - 8" Diameter - 1,600 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Wheel
- 8 Inch Wheel
- Wheel w Caster Assembly
- Fulton
more information >
Product Page this Question was Asked From
Fulton F2 Adjustable A-Frame Jack - Sidewind - 9" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- 9 Inch Lift
- Bolt-On
- No Wheel or Foot
- Fulton
more information >
Continue Researching
- Q&A: Replacement Bearings and Seals Based On Printed Number On Face Of Bearing
- Q&A: Outside Diameter of Shank Portion of Caster for F500266 Fulton F2 Adjustable A-Frame Jack.
- Q&A: Replacement Breakaway Cable Repair Kit for Dexter DX7.5L A-60 Brake Actuator w Electric Lockout
- Q&A: Dimensions of Demco A-Frame Trailer Coupler DM14793-97
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: Trailer Maintenance Schedule
- Q&A: Drag Roller Recommendation for Boat Trailer with Prop Protector Cut Out
- Q&A: Replacement Hub for Dexter 5200 lb Axle with Nev-R-Lube Bearings
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Tire Sizing
- Article: Best Boat Trailer Jacks
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)