Will Erickson ATV E-Track Tie-Down Kit Work With Brophy E-Track
Question:
Do I need backing plates for these wheel chocks and if I do will the backing plates fit
asked by: James K
Expert Reply:
Depending on what your plan on bolting the Erickson ATV E-Track Tie-Down Kit and Wheel Chocks # EM09160 to you may not need the backing plate # BPEZ. I have a picture attached where it's bolted to a truck bed with no plate.
However, if you want to use the Brophy E-track backing plate # BPEZ with the Erickson ATV E-Track Tie-Down Kit and Wheel Chocks # EM09160, they will work with each other but may need some adjustments.
Please note you will supply appropriate installation hardware for the ATV kit based on the requirements of the mounting surface where you will install it.
The four outside holes on the Brophy plate # BPEZ do generally align with the mounting holes on the ATV kit but we have found that it may sometimes be necessary to enlarge two of them to get the best fit. Just a little bit of drilling should be all that is needed.
Products Referenced in This Question
Erickson ATV E Track Tie-Down Kit w/ Ratchet Straps and Wheel Chocks - 1,500 lbs
- ATV-UTV Tie Downs
- E-Track Ends
- 1 Strap
- Manual
- 6 - 10 Feet Long
- E-Track Strap
- Ratchet Strap
- 1-1/8 - 2 Inch Wide
- 1201 - 1500 lbs
- Erickson
more information >