Draw Tite Hitch Cargo Carrier Recommendation for a 2010 Chevy Camaro
Question:
My 1-1/4 receiver is only 8 inches off the ground. Is this carrier going to work ok, or is this too low? Seems like the back end would hit the ground in some situations. What can you recommend to give it a rise of a few inches?
asked by: Mikie S
0
Expert Reply:
Considering how low to the ground the hitch opening is on your 2010 Chevy Camaro I would recommend the Draw-Tite Hitch Cargo Carrier # 6500 as it has an angled shank that raises the platform an additional 3 inches above the hitch opening.
I attached installation instructions for you to check out for this product also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
17x46 Curt Cargo Carrier for 1-1/4" and 2" Hitches - Steel - 500 lbs
- Hitch Cargo Carrier
- Flat Carrier
- Fixed Carrier
- 20 Inch Wide
- Heavy Duty
- Fits 1-1/4 and 2 Inch Hitch
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- 48 Inch Long
- Class I
- Class II
- Class III
- Class IV
- Steel
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: How to Determine Correct Rise or Drop for Blue Ox SwayPro Weight Distribution System
- Article: Trailer Maintenance Schedule
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Leaf Spring Replacing Dexter 072-078-00 For 4,400 lb Axle
- Q&A: Does Primer Need to Be Applied to Aluminum Roof Before Applying Alpha Systems 4034 Roof Coating
- Q&A: How Can I Remove RV Roof Coating From The Side Of My RV?
- Q&A: What Hitch Do You Recommend for a 2024 Toyota RAV4?
- Q&A: Height of Timbren Rear Suspension Enhancement System # TGMRCK25D
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Trailer Hitch Drop
- Article: Cargo Tie-Down Methods
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: My Trailer Hitch Doesn't Fit