Weight Capacity of Gen-Y Aluminum Loading Ramp Set 325-GH-R96
Question:
will this ramp support my 7900 lb. excursion, or will it bend like the original steel ramp that came with the car trailer
asked by: Doug M
Helpful Expert Reply:
The USA-made Gen-Y Aluminum Loading Ramps # 325-GH-R96 have a combined capacity of 10,000-lbs, well above your actual load of 7900-lbs, so I would expect no issues with loading your Excursion.
The ramps have 20% more capacity than you need and I would consider that a very reasonable safety margin. Each ramp weighs about 50-lbs despite their lightweight aluminum construction so that suggests that a lot of material is used in their fabrication.
I cannot comment on your original ramps since I do not know anything about their design or construction.
Product Page this Question was Asked From
Gen-Y Hitch Aluminum Loading Ramp Set - 8' Long x 15" Wide - 10,000 lbs
- Car Ramps
- Loading Ramps
- Open Trailer
- 15 Inch Wide
- 96 Inch Long
- Car Hauler Ramps
- 10000 lbs
- Gen-Y Hitch
more information >
Continue Researching
- Shop: Aluminum Car Hauler Ramp Set - 72" x 14-1/2" - 6,000 lbs - Qty 2
- Shop: Wheel Bolt, 1/2" x 1-5/8" with Right Hand Threads
- Shop: Gen-Y Hitch Aluminum Loading Ramp Set - 8' Long x 15" Wide - 10,000 lbs
- Video: Gen-Y Hitch Aluminum Loading Ramps Review
- Q&A: Recommended Hub and Drums for Motor Home Axle with 25580 Inner and LM67018 Outer Bearing
- Video: Race Ramps Trailer Loading Assist Ramps Review
- Video: Buyers Products Trailer Wiring Junction Box Review
- Video: Buyers Products Wiring 3375601100 Review
- Q&A: How To Ground Trailer Tail Lights Without a Ground Wire To a Wooden Surface
- Q&A: Ramp Recommendation for Loading Bobcat 331 Onto Trailer
- Shop: LED Trailer Combination Tail Light - Submersible - 7 Function - 10 Diodes - Red Lens - Driver Side
- Shop: Trailer Wiring Junction Box - 7 Terminals - Polypropylene
- Shop: Bright Way Push-to-Test Trailer Breakaway Kit with 1-Amp Charger and 5 Ah Battery - Top Load
- Shop: LED Combination Tail Light for Trailers over 80" Wide - Submersible - Red - Driver Side
- Q&A: Lighting Requirements for Trailer that is over 80 inches in Width
- Q&A: Determining If We Have A Replacement For A Dayton Fayette 9254 Hub and Drum Assembly
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: Availability of Bearing Kit BK3-310 with Larger Inner Diameter Grease Seal
- Search Results: seal cross reference
- Search Results: cross reference for seals
- Video: RoadMaster RoadWing Removable Expandable Mud Flap System Review
- Search Results: trailer ramps
- Video: Pollak Fifth Wheel and Gooseneck Wiring Harness Installation - 2021 Ram 2500
- Search Results: trailer jack stand
- Search Results: b&w offset ball
- Video: Curt Raw Finish Hitch Ball Review
- Search Results: trailer weight scale
- Search Results: analog scale