What Does The Flashing Red Indicator Curt Venturer Trailer Brake Controller Mean?
Question:
What would cause an overload and make it go from green bars to flashing red
asked by: Richard D
Expert Reply:
I checked with Curt and you are correct, the flashing red light indicates a brake circuit overload. Since the light is flashing that most likely means you have a short somewhere on the brake output circuit drawing too much power.
To correct this issue, we will need to test the brake controller # C74VV. Sever the brake output wire near the brake controller leaving enough room to reconnect it and then apply the manual slide. Using a circuit tester like part # PTW2993, you should get output to the controller side of the wire you severed.
If these connections check out and the brake controller is properly grounded then its not an issue with the brake controller. If it tests fine then the issue is either a short somewhere that is drawing too much power, or your trailer is actually overloading the controller. More than likely it's a short in the wiring somewhere or the connectors. To find the short, check the connectors, both the vehicle and trailer and inspect the wiring for any damage.
Products Referenced in This Question
Product Page this Question was Asked From
Curt Venturer NEXT Trailer Brake Controller - 1-3 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LCD Display
- Up to 360 Degrees
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Q&A: Flashing Red Signal With Curt Venturer Brake Controller
- Q&A: Troubleshooting Venturer Brake Controller Red Light Comes On Intermittently
- Q&A: Electric Trailer Brake Magnet Short Circuit Indicator on Brake Controller Comes On After Moving
- Shop: Hook Probe Circuit Tester
- Article: Troubleshooting Brake Controller Installations
- Q&A: How To Find Cold Side Of Stop Light Switch On Vehicle For Brake Controller Installation
- Q&A: Troubleshooting Trailer Braking System With Brake Controller Indicating OL or Overload Error Code
- Shop: Reese Weight Distribution Shank for 2" Hitches - 9 Hole Adjustment - 1,200 lb TW
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting No Power on the Blue Brake Output Wire from a Brake Controller
- Q&A: No Power On Blue Wire to Trailer Brakes from Brake Controller
- Video: Trailer Brake Controller Wire Testing
- Shop: Optronics LED Mini Clearance or Side Marker Trailer Light - Submersible - 2 Diodes - Amber Lens
- Shop: Optronics LED Mini Clearance or Side Marker Trailer Light - Submersible - 2 Diodes - Red Lens
- Shop: Curt Echo Under-Dash Bluetooth Brake Controller w/ OneControl App - 1 to 4 Axles - Proportional
- Shop: LED Trailer Mini Clearance or Side Marker Light - Submersible - 2 Diodes - Amber LEDs - Clear Lens
- Shop: Bezel for Optronics MCL13, MCL14, and UCL13 Series Side Marker/Clearance Lights - Black
- Shop: Suspension Enhancement
- Video: Dexstar Tires and Wheels - Wheel Only - AM20395 Review
- Video: Review of MB Sturgis Propane Fittings - Quick Disconnect Kit - 104052-401132
- Search Results: brake controller