Cutout Dimensions for the Valterra City Water Inlet # A01-2001VP
Question:
What are the cutout dimensions for the A01-2001VP?
asked by: Bill K
0
Expert Reply:
The cutout dimensions for the Valterra City Water Inlet # A01-2001VP need to be 5-1/2" Wide x 3-1/2" High. It states this on the back of the packaging. However, the raised section in the middle at the back measures about 5-3/4" x 3-7/16" so your cutout may need to be a little larger.
I have linked a review video for you to check out.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Valterra Dual RV Water Inlets - City Water and Gravity Fill - Plastic Valve
- RV Water Inlets
- City Fill Inlet
- Gravity Fill Inlet
- Surface Mount
- 1/2 Inch Deep
- Plastic
- 7-1/2 Inch Diameter Flange
- Plastic
- White
- Valterra
more information >
Continue Researching
- Shop: Valterra Dual RV Water Inlets - City Water and Gravity Fill - Plastic Valve
- Q&A: Wiring Needed To Operate Winch On Trailer From Truck Battery
- Q&A: How Much Space is Needed for Timbren Silent Ride for Tires Not to Hit Bottom of Trailer
- Q&A: Solution for Von Weise Fifth Wheel Landing Gear with Bad Motor
- Q&A: Everchill Model WD-282FWDC-B-6 RC refrigerator
- Q&A: Dimensions of Reese Goose Box RP85FR 94920
- Q&A: Can a 14125A Trailer Wheel Bearing Replace a 15123 Bearing
- Q&A: What Does B and W Patriot Slider Hitch RVK3270 Weigh
- Article: Ram Trailer Tow Prep Package
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Can You Flat Tow a Ford Escape?
- Article: Trailer Hitch Receiver Sizes
- Article: Double-Eye Trailer Suspension System Review