Does Adarac Ladder Rack Stake Pocket Mount Kit # A70432 Fit 2016 Ford F-150

Question

Question:

Will these work on 2016 Ford F-150? Or do you have another that will fit? Thanks

asked by: Gary W

0

Expert Reply:

There are Adarac ladder racks that fit your 2016 Ford F-150 like the part # A70490 if it's a 5.5 foot bed, part # A90630 if it's a 6.5 foot bed, or # A70590 if it's an 8 foot bed so the stake pocket mounts part # A70432 that you referenced will fit your truck.

expert reply by: Jameson C

0

Answer 1

Yes, the capture plate on the Stake Pocket Insert part #A70432 allows it to work on practically any stake pocket opening including the ones on your 2014 Ford F-150. It sounds like you may have an alternate application for these but nonetheless I have…

view full answer...

Answer 2

I had our warehouse measure the lower threaded bracket included with the Replacement Stake Pocket Insert for Adarac Custom Truck Bed Ladder Rack #A70432 and it measures 2-7/8" long x 2" wide and 3/16" thick as shown in the included…

view full answer...

Answer 3

Yes, because the Adarac Ladder Rack part #A70530 is a confirmed fit for your 2009 Chevy Silverado 6-1/2 foot bed the replacement stake pocket part #A70432 would fit the vehicle.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...