Installing a Brake Controller on a 2007 Newmar Canyon Star With a Workhorse Chassis
Question:
2007 Newmar Canyon Star with a GM Workhorse Chassis Is there a port or plug for easy hook up of brake controller or will it need to be wired all the way to the plug ?
asked by: Hank S
Expert Reply:
To install this in your 2007 Newmar Canyon Star with a Workhorse Chassis you will need to do a little bit of hardwiring as there are no plug-in connectors on your vehicle.
For a brake controller I recommend going with the Tekonsha Prodigy P3 # 90195. This brake controller is very easy to use due to the LCD screen and the information that it shows. It features settings that can be saved as well as easy troubleshooting codes. You will need to connect the wires from the pigtail that came with the P3 to the following functions:
Black - 12V Power
White - Ground
Blue - Brake Controller Pin on 7-Way
Red - COLD Side of Stop Light Switch (only gets hot when brake pedal is pressed)
Sometimes on a motorhome there will be a bundle of wires that goes to all of these functions. This will either be located under your driver side dash or under the driver's seat. You can verify the wire functions by using a circuit tester like part # PTW2993.
Let me know if you cannot find these wires and what kind of connector you have on your Canyon Star, and I can help you get the wiring that you will need for a brake controller.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Parts Needed to Tow a Trailer with a 2015 Honda Pilot