How Much Does Solera 6' Long Slider (Slide-Topper) # LCV000163274 Weigh

Question

Question:

how much does this awning weigh

asked by: Kevin

1

Helpful Expert Reply:

Solera 6' Long Slider (Slide-Topper) # LCV000163274 weighs approximately 22 pounds.

expert reply by: Michael H

1

Answer 1

To adjust the tension on your Solera RV Slide-Out Awning, #LCV000163285, you'll want to remove the slide topper from the brackets and reroll the awning roller 14 times to add enough tension to the springs. You'll also want to ensure your end…

view full answer...

Answer 2

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. Measuring is not required if you just take a look at your coupler and see where it attaches to…

view full answer...

Answer 3

The Curt Ball and Safety Chain Loop Kit for Chevy, Ford, GM, and Nissan Underbed Gooseneck Trailer Hitch #C60692 does not need to be greased unless the mechanism isn't working properly. A spray penetrating spray grease works well, don't over…

view full answer...

Answer 4

I would not recommend hooking up at a 90 degree angle for a couple of reasons. The trailer is not designed to take the force of the truck contacting the pin box at that angle. It would be very dangerous and unstable and could topple the trailer over…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

How Much Does Solera 6' Long Slider (Slide-Topper) # LCV000163274 Weigh

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching