What Material Is Interior Latch And Plate (Plastic Or Metal)

Question

Question:

In relation to: The Global Link RV Entry Door Handle. Item: 295-000019. I am wondering if the interior latch and interior plate are plastic or metal?

asked by: Scott

0

Expert Reply:

I went out to our warehouse to confirm the materials used for the interior latch and interior plate on the Global Link RV Entry Door Handle, Item # 295-000019. The interior latch, interior plate, and almost all the components seem to be made of metal. The interior "red" handle felt like a hard, tempered plastic.

I have attached a video that reviews the RV Entry Door Handle for you to check out.

expert reply by: Brint H

0

Answer 1

Thank you for submitting a photo of your vehicle wiring. Your 2000 Chevrolet Silverado pickup should have a trailer wiring harness at the rear bumper. This harness is often tucked in behind the spare tire or zip-tied to other wiring or to the vehicle…

view full answer...

Answer 2

To convert your barn door on your Wells Cargo enclosed trailer to a ramp door I would recommend you use the Universal Cam-Door Lock for Enclosed Trailers #383200 that you referenced as well as a 3/4 diameter pipe that you will need to get from a…

view full answer...

Answer 3

Trailer ramp spring #362SW61 could work provided that the interior of the trailer is wide enough for the rod (the rod can be trimmed down as low as 48 inches). The capacity of this spring is 120 pounds so it will help when both raising and lowering…

view full answer...

Answer 4

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 5

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 6

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

I believe I have a solution for you, but I think you may need to remeasure your cutout and/or compare the measurements of your current latch with one of ours. Since latches tend to be fairly universal in size when it comes to the RV world the Global…

view full answer...

Answer 9

The Global Link RV Entry Door Locking Latch Kit #295-000019 that you referenced would be the correct fit for your 2010 Keystone Montana as this is a fit for standard RV doors like what your Montana has. I attached a review video link for this latch…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

What Material Is Interior Latch And Plate (Plastic Or Metal)

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching