Does Replacement Fender for Malone Trailers Come with Mounting Brackets

Question

Question:

I am trying to verify the new fender comes with the mounting bracket / arm to bolt to the frme?

asked by: Jeremy W

0

Expert Reply:

Aluminum Diamond Plate Fender for Malone MicroSport and MicroSportXT Trailers # MPG602 is just the fender by itself. It looks like the fender just uses a couple of L-brackets to mount. You can use pair of brackets # PF775-BKT-2. Hardware you can get locally to save money. The brackets that come with the trailer are not available as a separate part.

expert reply by: Michael H

0

Answer 1

From what I can find online, it looks like the 2-Leaf Slipper Spring w/ Radius End for 1,000-lb Trailer Axles - 24-5/8" Long, #SP-177275 is the best upgrade option for your malone Microsport trailer. This spring is 24-5/8 inches from the center…

view full answer...

Answer 2

Yes, leaf springs must be replaced in pairs which is why one side left go and then the other shortly after. In regards to the stent you get on a full set of leaf springs, there are really a ton of variables present here so it is hard to predict.…

view full answer...

Answer 3

The reason that you cannot find a list of all load ranges and the weight capacity for each in regards to trailer tires is because it will be different for each size. For example, a 205/75-15 tire like part #AM10245 which has a load range D rating is…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 11

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 12

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Does Replacement Fender for Malone Trailers Come with Mounting Brackets

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching