Installing Pop & Lock Custom BOLT Lock Tailgate Handle PAL8540 in 2014 Toyota Tacoma
Question:
Do I need to run a new line from the tailgate to the front of the truck to have a power lock?
asked by: Dale
0
Expert Reply:
If your 2014 Toyota Tacoma has power locks already then the Pop & Lock Custom BOLT Lock Tailgate Handle # PAL8540 will simply wire into that power lock circuit. If the truck does NOT have power locks already then you will need to provide 12V power and use Switch Kit # PAL9520.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock with Handle - Power Lock and Manual BOLT Lock - Black
- Tailgate Locks
- Tailgate Handle
- Power and Manual Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How To Confirm Fit of Rear View Safety Backup Camera for Pickup Trucks
- Article: Performance Chips and Modules
- Article: Roof Rack Information
- Article: Rooftop Cargo Carriers
- Q&A: Where Are The Wires For Pop & Lock # PL8540 Located In A Two Door 2015 Toyota Tacoma
- Q&A: Difference Between PAL8540 and PAL8550 For a 2007 Toyota Tacoma
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Q&A: Camera Mounting Clip for Pop & Lock PAL5400 Custom Tailgate Handle with Lock
- Q&A: Tailgate Handle with Backup Camera for a 2015 Toyota Tacoma
- Q&A: Locking Tailgate Handle Recommendation for a 2014 Toyota Tacoma with Back Up Camera