How Does Switch for RAM Jack Remove and Install

Question

Question:

The button on the jack that riases and lowers it popped out. I saw the replacement part but is there an instructional video?

asked by: Teresa M

0

Expert Reply:

We don't have an install video but basically what you have to do is remove the outer shell of the jack and then squeeze the top and bottom of the switch so that it can push through the mounting hole and then pop the new one in place.

expert reply by: Jameson C

0

Answer 1

There isn't a wrong way to install the Replacement Power Switch #EJ-3520-PSW for your Electric Jack #EJ-3520-BBX, just a wrong way to wire it. So long as you wire it like you see in the accompanying photo you won't have any issues.

view full answer...

Answer 2

If you check out the picture I attached you can see how the wires of the Ram jack switch #EJ-3520-PSW are supposed to be ran to it.

view full answer...

Answer 3

It could be a switch or it could be the wiring to the switch not seating all the way. I would recommend pulling the switch out to see if the wiring is good and if it is then replace the switch with part #EJ-3520-PSW.

view full answer...

Answer 4

I have attached a photo you can use to connect the Replacement Power Switch #EJ-3520-PSW to your 3,500 lb RAM jack. We don't have a direct wiring diagram but if you notice even though the wires are the same colors they look pretty different so…

view full answer...

Answer 5

I attached a picture that I got from RAM jacks that shows how the RAM Jack switch part #EJ-3520-PSW that you referenced gets wired up.

view full answer...

Answer 6

To replace a switch on your RAM 3,500 lb jack you just need the Replacement Power Switch #EJ-3520-PSW, but this also could be a bad internal screw. To determine if it's the switch or the screw you just need to remove the plug on top of the jack…

view full answer...

Answer 7

Your RAM 3550 Jack will use both the Replacement Power Switch for RAM Electric Trailer Jack with Footplate #EJ-3520-PSW and the Replacement Light Switch for Electric Trailer Jack with Footplate #EJ-3520-LSW.

view full answer...

Answer 8

The Replacement Light Switch #EJ-3520-LSW that you referenced does include the bezel piece you sent in a picture of that's broken on your jack. Whoever you bought this from should cover the replacement since it showed up like this. I checked our…

view full answer...

Answer 9

Your RAM jack model ej-3550-bbx will use the Replacement Light Switch #EJ-3520-LSW and Replacement Power Switch #EJ-3520-PSW.

view full answer...

Answer 10

What you need to replace the light in your Ram Jack a-frame powered jack is the part #EJ-3520-LT.

view full answer...

Answer 11

For your 1999 Ford F-350 Super Duty the Air Lift kit part #AL57390 is listed as a fit on our site and with Air Lift. I double checked to be sure. I attached a picture that shows how this install using L-bracket style fifth wheel rails as well for you…

view full answer...

Answer 12

When RV slide outs start grinding the issue is sometimes something dragging on something else in the track. It can be that the tracks had something fall into them and now that is what you are hearing or they are misaligned. Sometimes it can also be a…

view full answer...

How Does Switch for RAM Jack Remove and Install

Product Page this Question was Asked From

Continue Researching