What are the Sizes of the Hitch Balls on the B&W Tow & Stow 2-Ball Mount # BWTS20037B

Question

Question:

what size hitch balls are on the BWTS20037B

asked by: Jon

0

Expert Reply:

The B&W Tow & Stow 2-Ball Mount # BWTS20037B that you referenced has 2 hitch balls that have different weight ratings.

The 2 inch hitch ball is rated for 7,500 lbs and the 2-5/16 inch hitch ball is rated for 18,000 lbs.

These hitch balls can be configured a number of ways by pulling the pins and either turning the hitch balls or flipping the ball mount under the shank.

expert reply by: Jon G

0

Answer 1

Good news! The Bulldog Winch #BDW15019 will work great for loading your 18 foot car hauler with a vehicle up to 4,000lbs. We recommend using a winch with a line pull capacity no less than equal to that of the load being moved. For example, if a car…

view full answer...

Answer 2

The SuperWinch LT2000 Electric Utility Winch, part #1120210, you have referenced will only have a rated line pull of 2,000 lbs. The rated line pull of 2,000 lbs. will pull a rolling load of 10,050 lbs. up a 6 degree incline, but as the incline…

view full answer...

Answer 3

If you installed a decently sized deep cycle battery on your trailer you wouldn't have a problem powering the LED lights of it for the length of time mentioned since LED lights draw a fraction of the amperage as incandescent. Group 24, 27, and 31…

view full answer...

Answer 4

Hi Alec, The Inno Kayak Roof Rack w/ Tie-Downs #INA452 needs a 28" minimum spread so that the saddles sit at the right spot for the kayak and support the weight properly. This is probably just a general guide from Inno though because the length…

view full answer...

Answer 5

I looked up the trailer connector wiring diagram for a 2007 Ford F-250 which should be the same as a Ford F-350 and found the 7-way trailer connector to contain the following wires: Orange = 12 Volt Power White = Ground Black/Green = Reverse Blue =…

view full answer...

Answer 6

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 7

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 10

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

What are the Sizes of the Hitch Balls on the B&W Tow & Stow 2-Ball Mount # BWTS20037B

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching