How to Determine Spindle Size for a 2004 Triton Elite WCII PWC Trailer
Question:
Im looking to find out what spindle I need to replace the chewed up spindle on my 2004 Triton elite WCII jetski trailer? Also how do you go about replacing the spindle? Thanks,
asked by: Glen
Expert Reply:
There are two ways to determine what spindle you have on your 2004 Triton Elite WCII Jet-Ski trailer.
The first way is to look at the number that is stamped on the bearings that you removed when you took the hub off.
The second way is to use a dial caliper and get the measurements and find the spindle that matches those measurements.
The new spindle must be absolutely square with the axle in order to prevent tire wear and wheel tracking problems. I would recommend finding a welder who is experienced with trailer axles. Your local RV dealer or repair facility could probably refer you.
Product Page this Question was Asked From
Square #84 Spindle for 3,500-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- 1-1/2 Inch Diameter
- Square
- For 3500 lb Axle
- TruRyde
more information >
Continue Researching
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Grease Seal to Replace 127194TB
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Q&A: How Does the Correct Track Trailer Alignment and Lift Kit Really Work
- Q&A: Does Correct Track Trailer Alignment Kit # RR23QX Come with Enough Brackets for Tandem Trailer
- Q&A: Will the Correct Track Trailer Alignment and Lift Kit Prevent Nose High Towing
- Q&A: Replacing Parallex 7345 Converter to One that is Compatible with Lithium Batteries
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings