Is Plumbers Tape Required to Thread Brake Line to Demco Surge Actuator # DM72VR
Question:
The brass fitting that comes with this is loosely screwed into the plastic master cylinder. Do I need to install plumbers tape between the brass fitting and the plastic master cylinder?
asked by: Pete
0
Expert Reply:
It's not required. When we've installed the Demco actuator we used part # ALL644044 and we did not use any thread tape or anything like that it was just fine. I attached an install video for this coupler for you to check out as well.
expert reply by:
Jameson C
0
Products Referenced in This Question
Powerbuilt Beam-Type Torque Wrench - 1/2" Drive - 0 to 140 ft-lb
- Automotive Tools
- Wrenches
- Torque Wrench
- 140 ft/lbs
- 1/2 Inch Drive
- Powerbuilt
more information >
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Bolt-On
- 7000 lbs GTW
- 2 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Demco
more information >
Continue Researching
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Q&A: Replacement Surge Brake Actuator For Atwood 85736 That Is Discontinued
- Q&A: Replacement Surge Brake Actuator For Atwood 61101
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Article: Most Popular Wheel Bearings
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)