Brake Controller Recommendation for 2015 Chevy Traverse
Question:
Where would you recommend mounting the controller? And how difficult is it to connect? Also how to access the wires that run to the back of the car? Thank you
asked by: Keith
Expert Reply:
Your 2015 Chevy Traverse should have a 7-way trailer wiring connector present at the rear of it. If it does not you'd need the part # 118271 to give you one that taps into the factory wiring. Then all you'd need is a wiring harness designed for your vehicle like the part # 3026-P.
For a brake controller I would recommend the Prodigy P3 Brake Controller part # 90195. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes. This will be the last brake controller you buy. It can easily be transferred to future vehicles as well.
Products Referenced in This Question
T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Tekonsha
more information >
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - GM
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Replacement Leaf Spring for Trailer with Dexter 4,400 lb Axle
- Q&A: Replacement Leaf Spring Replacing Dexter 072-078-00 For 4,400 lb Axle
- Q&A: How to Add Tension to Solera Slide-Topper
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Q&A: Recommended 7000lb Leaf Springs To Replace Dexter 072-027-00
- Article: Best Ladder Racks
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
Keith
10/9/2017
Where would you recommend mounting the controller? And how difficult is it to connect? Also how to access the wires that run to the back of the car? Thank you