Could Access Toolbox # 834532001859 Fit with Low Profile Tool Box
Question:
I have a 2017 Ram 2500 8foot bed with a low profile tool box. Will I be able to access the release handles on the tool box with this cover installed? There appears to be a gap between the box and the cover that would allow access but all of the photos show standard profile boxes so it is hard to tell.
asked by: Peter
0
Expert Reply:
If you check out the picture I attached you'll see how tight the part # 834532001859 installs to a tool box and it's relation to the bed rail height. You should be able to tell from that if your latches would be accessible. If the latches are below the bed rail height then most likely no.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Access Toolbox Edition Soft, Roll-Up Tonneau Cover
- Tonneau Cover
- Roll-Up - Soft
- Rack Compatible
- Tool Box Compatible
- Opens at Tailgate
- Standard Profile - Inside Bed Rails
- Vinyl
- Vinyl Grain
- Access
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Replacement Automotive Lighting
- Article: How to Choose the Best Tonneau Cover
- Q&A: Recommeded Tonneau Cover to Use With a 5th Wheel Hitch on a 2017 Ford F-350 Super Duty
- Article: Trailer Lighting Requirements
- Q&A: Recommended Programmer for 2004 Ford F-150 with Triton V8 5.4 Liter Motor
- Q&A: Will The MORryde Cushioned Pin Box Replace A Lippert Rhino Pin Box
- Q&A: Trailair Pin Box Replacement For A Lippert Rhino Pin Box
- Q&A: Which Flex Air Pin Box Fits 2022 Grand Design Momentum 351 MS
- Q&A: Is The Reese Goose Box Available for the Rhino Box?
- Q&A: Compatible Replacements For A Lippert Rhino Box Pin Box On A 2021 Cedar Creek 37MBH
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Using a Portable Generator on RV