Where Do Plunger and Rubber Socket Door Holders # PLR62-66 Typically Mount, High or Low
Question:
Hi, Are these normally mounted at the top of the doors so you dont run into them if mounted lower?
asked by: Chip
0
Expert Reply:
I've seen rubber socket/plunger kits like the part # PLR62-66 on the bottom of the doors more frequently than the top. That could very well be because it's easier to install them lower though.
If you prefer them at the top there's no reason you couldn't. It would probably stress the door less having them up top too since that would be closer to where you'd be pulling on the door from.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 1-3/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- 1-3/4 Inch Plunger
- 2-1/2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Installation of Hitch on Fifth Wheel Trailer
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams