Could Ultra Fab Hitch Part # UF35-946402 Fit Bumper Measuring 3 inch by 3 inch
Question:
I would like to mount this hitch to our pop up camper bumper but the bumper is only 3x3. Will it mount securely on this size bumper?
asked by: Matt
0
Expert Reply:
Since your bumper is 3 inch by 3 inch the Ultra Fab hitch part # UF35-946402 that you referenced can fit it but you would need to use a 1 inch spacer on the top/bottom and another one on either side so that it fits properly since this is designed for a 4 inch by 4 inch bumper. The spacer would essentially make the bumper 4 inch by 4 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ultra-Fab 2" Motor Home Trailer Hitch Receiver for 4" x 4" Bumpers - 3,500 lbs
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 100 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Recommendation For Increasing Strength of Rear Bumper Attached to Spacers Off Of Trailer Frame
- Article: How to Carry Bikes While Towing a Travel Trailer
- Q&A: Replacement Grease Seal for a 168255TC Rubber Coated Seal
- Q&A: Replacement 250-031468 Seals Needed for Reliable Oil Bath
- Q&A: SuperSprings Custom Stabilizer and Sway Kit For a 2004 Chevrolet Silverado 2500HD
- Q&A: Can Single Wire Clearance Light Be installed To Replace 2-Wire Light On Travel Trailer
- Q&A: Will the Replacement Red Lens # A42RB Replace Do Ray SS-105
- Q&A: Replacement For Axxera AV615BHM RV Stereo
- Article: Trailer Tire Sizing
- Article: Best Bike Racks for Electric Bikes
- Article: How to Charge a Dump Trailer Battery
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)