Troubleshooting S.H. Display on Tekonsha Prodigy P2 Trailer Brake Controller
Question:
Setting up prodigy 2 brake controller When the rv is running and towing car on dolly, the setting goes to 5.H. what does it mean?
asked by: Joe
Expert Reply:
The Tekonsha Prodigy P2 Trailer Brake Controller # 90885 will display "S.H." (flashes 2 times per second) when it senses a short on the brake wire. It also can be caused by some test lights or non-Tekonsha circuit testers.
If the test lights are not the issue, then I recommend checking to make sure both the vehicle and tow dolly connector are free of debris or corrosion. Also check along the wiring for any pinched or damaged areas that might be leading to a short. It could be that there is an exposed piece of wiring that is making contact with the trailer frame.
If you are still unable to resolve the issue, please let me know and I will be happy to look into this further. I have also attached a brake controller troubleshooting article that you might find helpful.
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: Replacement Trailer Jack Recommendation for Dutton-Lainson Jack on Ranger Trailer
- Q&A: Troubleshooting Kodiak 225 Trailer Brake System that Keeps Breaking Calipers In Half
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
Chris P.
6/8/2020
just put a Prodigy p2 on a 2011 ford ranger and set to 6 on manual lever when i put foot on the brake i don't get a volt reading when i set it at 12 volts and use foot brake i get a reading of about 4.9 volts can you help